Introducing the GRT - Glock Reset Trigger!

This forced reset trigger is compatible with all Gen 1-4 Glock handguns and Glock clones.(Will not work in .22lr Glock models!)

The GRT is a partially skeletonized, textured, flat face, one-piece forced reset trigger manufactured using high grade stainless steel.

Installing this one-piece FRT on a Glock or Glock clone is a quick and simple process:

Preparation & Disassembly

1. Clear the firearm: Verify the chamber is empty, remove the magazine, and field-strip the slide from the frame.
2. Remove pins: Punch out the rear frame pin and the trigger housing pin, then pull out the locking block and trigger assembly.
3. Strip the bar: Punch out the pin holding the factory trigger shoe to the trigger bar.

GRT Installation

1. Mount the trigger: Align the GRT onto the trigger bar.
2. Secure the pin: Drive a secure 2x8 roll pin through the trigger shoe and bar to lock it firmly in place. Stainless steel roll pins are recommended.
3. Reinstall housing: Drop the completed trigger assembly back into the frame and finish reassembling the handgun.

Tuning Tips

• Check compatibility: Gen 5 or slimline models are not officially supported and may require swapping to an older-generation slide release or adjusting component compatibility to retain slide-stop features. On Gen 5 models, the ambi slide release can be swapped for the single side slide release from previous generations.
• Polishing recommended: Manual polishing of your GRT and trigger bar is recommended.
• Additionally, a careful "25 cent trigger job" is always recommended!
• Recommended Parts: It is recommend to use a 3-3.5 lb connector, and depending on your setup, a high power recoil spring.