EZ Bear Micro Optic Mount for Glock Dovetail – No Slide Milling Required (Adapters for Holosun K & Shield RMSc Footprints)

Mount your red dot without cutting your slide. The EZ Bear Optic Mount replaces the rear sight and is compatible with any non-MOS Glock (Gen 1–5) and includes an optic-height black-out front sight. Choose your adapter below for Holosun K-series, Shield RMSc, or similar footprints—no slide milling required.

Overview

The EZ Bear Micro Optic Mount is a drop-in dovetail solution for shooters who want an optic-ready solution compatible with Glock handguns without sending their slide off for milling.
Machined from 4140 steel and finished in black nitride, this mount slides directly into the factory rear-sight dovetail and locks down tight for a rock-solid zero. Every kit includes an optic-height black-out front sight, giving you a clean sight picture and proper co-witness with most micro-red-dot footprints.

Features

• Fits all non-MOS Glock models (Gen 1–5) with standard dovetail rear sight

• No slide milling required — installs in minutes

• 4140 steel construction with durable black-nitride finish

• Includes optic-height black-out front sight

• Two screw sets and rubber pad included for secure mounting

• Torque to OEM optic specs (do not overtighten)

• Made in the USA

In the Box

• 1 × EZ Bear Base Plate Adapter (choose #1 or #2)

• 1 × Optic-height black-out front sight

• Mounting screws (two styles) + rubber pad

• Installation instructions / QR code link

Compatible with all non-MOS Glock models Gen 1–5.

 *If your micro-optic model isn’t listed above, we recommend adaptor #2
Not for factory optics-ready slides.

Installation Notes

• Remove factory rear sight before installing
• Apply blue Loctite in dovetail cut of slide
• Drift mount into dovetail and center in slide
• Install rubber pad on ABA adaptor
• Install your micro red dot 
•  Apply blue Loctite in screw holes before installing screws
• Torque to OEM optic manufacturer specifications
  • Use blue Loctite only — do not use red Loctite or overtighten screws
• Verify zero before carry use

How It Works

1. Remove Rear Sight → drift out your factory sight

2. Install EZ Bear Plate → slides into dovetail and locks in place

3. Mount Your Optic → attach optic using included screws and torque to spec

Simple. Secure. No milling required.